[. . . ] KY-T937SL KY-T937XL KY-T937XL English Deutsch FOR DOMESTIC USE ONLY NUR FÜR HAUSHALTSÜBLICHEN GEBRAUCH ZY02-G05 Thank you for purchasing this Panasonic appliance. IMPORTANT SAFETY INSTRUCTIONS: Before operating this appliance, please read these instructions carefully and keep for future reference. Before the installation: Locate the serial number sticker on the rear side of the appliance. When electricity flows in the magnetic coils underneath the top plate, magnetic lines of force are produced. [. . . ] (See page 15) ■ Ensure the top plate and bottom of the pan are dry and clean. – Do not add ingredients before the temperature display stops flashing. – Once preheating has started, do not add oil or move the pan to another cooking zone. Deep/Shallow Frying Mode WARNING ) with When deep/shallow frying, use Deep/Shallow Frying Mode ( minimum 200 g oil at least 1 cm deep. Failure to observe this warning may cause oil to overheat resulting in a fire. 1 -9 For the cooking zone with , touch [Sensor] key once to select Deep/Shallow Frying Mode. When the set temperature is reached, the temperature display stops flashing and the appliance beeps 5 times. (See page 17) NOTE ■ Deep/Shallow Frying Mode cannot be used on an area that covers more than one flex cooking zone. – The actual oil temperature may vary from the set temperature depending on the cookware. (See page 27) English 180 180 EN- 24 EN- 25 IH Cooking IH Cooking Using Cooking Timer Used to switch a cooking zone off automatically. – Menu bar will appear from bottom of the control panel after selecting the cooking zone. – Menu bar will close downward if 5 seconds has elapsed without any operation. To revert Timer Timer Using Kitchen Timer Used independently from all other cooking functions. – Menu bar for timer setting will appear from bottom of the control panel. – Menu bar will close downward if 5 seconds has elapsed without any operation. Cancelling Kitchen Timer Touch Kitchen Timer key ( or ■ Set the timer to “0:00”. To revert Cancelling Cooking Timer Touch the cooking zone selector once, and touch key, then; or ■ Set the timer to “0:00”. ) again, then; English Adjusting countdown time Once countdown has started, the timer can be adjusted. When the timer reaches “0:00”, the appliance beeps 5 times and turns off the cooking zone. Adjusting countdown time Once countdown has started, the timer can be adjusted. When the timer reaches “0:00”, the appliance beeps 5 times. NOTE ■ Once the cooking timer has been set, it is not possible to revert to the count-up timer. [. . . ] (2 places at rear) ■ Place the appliance on the packaging upper filler when fitting clamps to prevent damage to the countertop. – Match the clamp grips with the holes on the sides of the appliance, then slide the clamp from the right to the left to fasten them to the appliance. Flush-fitting (measurement: mm) This appliance can be fitted flush when installing. Installing the appliance as flush-fitting ■ Only suitable for installation on heat and water resistant worktops such as marble, natural stone, solid wood (if cut out edges are sealed). [. . . ]